Point Guard MC 6005 Blue
Point Guard MC 6005 Blue is a heavy-duty, semi-synthetic coolant that can be used on cast iron, all steels, aluminum, and most other non-ferrous metals. A blend of extreme pressure additives and high petroleum oil content enables this product to be used in the most severe applications. In most cases, it will outperform heavy-duty soluble oils while still providing the benefits of a semi-synthetic coolant. It is balanced to provide good tramp oil rejection, allowing for ease of their removal. This product was designed to provide excellent corrosion protection, even under hard conditions, low foam and long sump life. As with all our semi-synthetic coolants, this product is free of any hazardous components, including diethanolamine, which makes it environmentally friendly and safe to use. This coolant can be used in a wide variety of applications, including milling, drilling, turning, boring, tapping, and grinding.
EXCELLENT BACTERIA & FUNGUS RESISTANCE
HIGH TRAMP OIL REJECTION
NOT IRRITATING TO SKIN
MILD, NON-OFFENSIVE ODOR
EXCELLENT CORROSION PROTECTION
DOES NOT REMOVE PAINT OR DAMAGE MACHINES
GOOD HARD WATER STABILITY
Point Guard MC 6005 Blue contains a high amount of extreme pressure agents along with a high petroleum oil content. These additives work synergistically to provide excellent film-boundary lubrication and heat dissipation at the tool/part interface, providing excellent tool-life and part finish. This coolant will outperform most semi-synthetic and soluble oil type products.
Monitoring Point Guard MC 6005 Blue:
The concentration can be monitored by refractive index using a refractometer. The table below will show concentration levels relative to refractometer readings.
For most applications, Point Guard MC 6005 Blue should be used in an operating range of 5-10% (20:1-10:1) for machining and 3-5% (33:1-20:1) for grinding. When mixing, add the coolant concentrate to water and mix thoroughly. It is best if the coolant concentrate and water are mixed in a separate container prior to adding to your system. This product is compatible for use with all types of pre-mixing and proportioning equipment. The sump life of this coolant, as with any other, will be greatly enhanced if charged to a clean bacteria-free system.
APPEARANCE, CONCENTRATE: CLEAR, BLUE OR CLEAR
APPEARANCE, 5% DILUTION: HAZY, BLUE OR CLEAR
SPECIFIC GRAVITY (G/mL): 1.007
POUNDS PER GALLON: 8.4
pH 5% DILUTION: 9.30 +/- 0.25
FREEZE/THAW: PASS 3 CYCLES
HARD WATER STABILITY: >1000 PPM
CAST IRON CHIP RUST TEST (2%): PASS
Point Guard MC 6005 Blue is available in 5 gallon pails, 55 gallon drums, and 275 gallon tote quantities.
*Refer to material safety data sheet for additional information about this product.